Till sidans innehåll

Microphone Preamp

  • For condenser microphones
  • Extremely low-noise Class A JFet amplifier
  • XLR 3-pin female to XLR 3-pin male
  • 18 dB gain (@3 kOhm load)
  • 4 Coordinated JFets
  • 48 V Phantom power
  • Transfers phantom power to the microphone
  • Tillgänglig sedan Maj 2018
  • Artikelnummer 439148
  • försäljningsenhet 1 Styck
  • Channels 1
  • Number of microphone inputs 1
  • Instrument input No
  • Tubes No
  • Compressor/Limiter No
  • Equalizer No
  • De-Esser No
  • Phantom power No
  • Phase Reverse No
  • External effect loops No
  • Analogue Outputs XLR
  • Digitale Outputs 0
  • Headphone connection No
  • Level Meter No
  • Design Adaptor
869 kr
Alla priser inklusive moms
i lager
1

134 Kundbetyg

4.7 / 5

drift

funktioner

ljud

hantverkskvalitet

83 Recensioner

d
Clean boost for the buck!
datstma 05.10.2020
Does exactly what it says on the box, will boost your low signal mic's, or if you need to use that way to long cable, then the FetHead will save the day. I highly recommend getting this one, since it acts as a phantom power pass-trough. Yes, it has about 10db less of a boost than the non-pass trough, but I don't use mic's that has on-board power anyway. :-)
drift
funktioner
ljud
hantverkskvalitet
0
0
Anmäl recension

Anmäl recension

G
Superenkelt
Gelius 03.01.2023
Bara koppla in direkt efter mickrofonen och köra. Inget krångel, bara mer ljud.
drift
funktioner
ljud
hantverkskvalitet
0
0
Anmäl recension

Anmäl recension

google translate gb
Tyvärr uppstod ett fel. försök igen senare.
z
Perfect for my needs
zorglub76 08.03.2021
First of all, I don't have a producer's ears. So when I say that there's absolutely no noise when using these preamps, take it with a grain of salt.
I have a specific problem that I tried to solve with the FetHead, and I solved it easily. The problem is that I'm getting some digital noise in my Focusrite Scarlett whenever I turn gain passed 1 o'clock. I don't know if it's a psu, or the nearby laptop or something else, but I couldn't get rid of it.
Now, with the FetHeads, I pre-amplify my mic, and I need just a slight gain from Scarlett, so the noise is gone! The sound is exactly the same as without the FetHead, just louder. I hear no distortion or noise. I'm using Lewitt small diaphragm mics that are especially noiseless, but I hope the others would behave the same.
I'd recommend FetHead as a cheap solution to any gain related problems you might have.
drift
funktioner
ljud
hantverkskvalitet
7
0
Anmäl recension

Anmäl recension

google translate gb
Tyvärr uppstod ett fel. försök igen senare.
L
perfect for hydrophone drop rigs
LutherD 16.04.2026
I use these preamps for a very particular purpose. I sometimes record with some DIY self built hydrophones (the gladys hydrophones), and in more quiet environments their output is very low, barely raising above the noise floor. This preamp solves this. Especially handy when I leave the hydrophones overnight with a Zoom F3 drop rig, a recorder where you can't really set the input level. The TritonAudio FetHead Phantom provides a clean and transparent gain and I can hear the signal from the gladys much more clearly, and I have less work in post. These preamps have been on some rather rought and adventurous trips, but they handle that without any problem. I also love the very small formfactor, which is very handy in field recording. I did subtract one point since the logo of one of them came off, but that didn't influence the sound.
drift
funktioner
ljud
hantverkskvalitet
0
0
Anmäl recension

Anmäl recension