Till sidans innehåll

Set of Machine Heads for Electric Bass

  • 50% Weight reduction compared to conventional bass machine heads
  • Made of carbon and refined aluminium
  • Configuration: 4 left
  • Semi-open design
  • Button: M4 Light Button
  • Gear ratio: 1:22
  • Shaft length: 17.6 mm
  • Bore diameter: 17 mm
  • Mounting: Pins and locking nut
  • Schaller no: 10270201.22.73
  • Surface finish: chrome-plated
  • Includes banjo bolts and washers
  • Made in Germany
  • Tillgänglig sedan Mars 2010
  • Artikelnummer 245178
  • försäljningsenhet 1 Styck
  • Colour Chrome
939 kr
Alla priser inklusive moms
i lager
1

48 Kundbetyg

4.4 / 5

hantverkskvalitet

39 Recensioner

google translate gb
Tyvärr uppstod ett fel. försök igen senare.
Tf
A bit of work to fit but worth it
Tim from UK 14.10.2017
These were to upgrade my Squire Affinity JB 5 string which was a present for me. Thomann were great as they were able to source the fifth machine head with the same orientation as the other four. I must say, that it took some modification to the headstock to get them fitted so if the holes are different on your bass you may wish to get these professionally fitted. The bass now has new Machine heads, new Pickups, new pre amp and new Pickguard. A bit of a project for me but I really like doing this to a cheap bass to get the upgrade
hantverkskvalitet
3
0
Anmäl recension

Anmäl recension

google translate gb
Tyvärr uppstod ett fel. försök igen senare.
JK
Works as expected
James K. 20.07.2021
Bought for a project upgrade bass, very easy to install and very sturdy despite being so light and made of aluminium and carbon fibre. Would definitley purchase these again
hantverkskvalitet
1
0
Anmäl recension

Anmäl recension

google translate gb
Tyvärr uppstod ett fel. försök igen senare.
M
Mateii 31.08.2020
I find them to be really good looking. I got them installed without any major surprises.
On the down side, two of the tuners have a bit too much friction when turning them. It is very hard to describe the feeling, and just marginally bothering
hantverkskvalitet
1
1
Anmäl recension

Anmäl recension

google translate gb
Tyvärr uppstod ett fel. försök igen senare.
N
An absolute pain to install by yourself
Nickojr 29.10.2025
The pegs mean you cannot lay the tuning pegs flat to the headstock to make accurate measurements, which makes installing them very awkward. It is very difficult mark correctly where the pilot holes should be, and I personally have made a mess of my headstock and had to buy wood filler and start again. I probably should have been more patient and made more of a plan for installing them, but either way it's not a very user friendly design. I really think Schaller should have a guide on the best way to install these.

Aside from the installation they are expensive light weight tuners that look nice and get the job done.
hantverkskvalitet
0
0
Anmäl recension

Anmäl recension