Oh Dear, I do not know where to start, but here goes, the cavity of the controls is slanted and the screws will only attach to the one side, on the pick guard side, the other side is just in free air, no wood there, so no way to anchor a screw.
The neck heel is 56 mm, while the body is 53 mm where the neck meets the body, which means that the neck sticks out a couple of mm, in my case on the top side, not a good playability issue, the ferrules on the back are in such a mess, from E to E string it's 5 mm slanted, the chrome on the saddle is so badly done that you see the copper tone of whatever material is used.
The Wilkinson logo on the neck pickup is in the angle where the metal is bent, not on top of the pickup.
The pickup guard is the worst i have ever seen, of the eight screws holding it in place, not a single one screws vertically they are all in an angle and cannot be "sunk" and the pick guard itself was so badly cut that I actually laughed!
If you decide to purchase this guitar perhaps you could make an instrument out of the wood, but other than this my advice is, save your money or buy any Ibanez or Yamaha, they are china or Indonesian made, but to a specific measure that apparently HB do not live up to.
I regret buying this!
