Rockboard LED Damper Large

I live in Sweden and half the year it's pitch black outside. Sitting at home after a long day at work and building a pedalboard is sometimes the only consolation. But then when you're playing through the dark winter evenings and half of the pedalboard consists of old pedals from EarthquakerDevices, you're basically completely blinded by the white LED lights.

Enter the Rockboard LED Damper!

It has a self-adhesive sticker that is just the right amount of pressure. You can easily remove it without damaging the paint and even reuse it a few times if you need to. It dims the LED light enough not to blind you, but not too much so that you can't see your tap tempo signal. Before I bought the light dampers, for example, I could barely play the Organizer, Avalanche Run, Transmisser or Hummingbird and see what settings they had without turning on all the lights in the room.

Now I can sit comfortably in dim light, see all the settings and enjoy the fact that I'm not going to have permanent vision damage.

It's a little sticky faceted cover that goes over your bright pedal LEDs.

The plastic is very slightly smoked to reduce the brightness, and overall it works well.
The adhesive used is good enough when the pedals live on a board, but if you carried them loose in your gig bag the damper may get knocked off.
I would have liked the base of the damper to be made from the same clear plastic so you can see more of the light.
As it is the silver base blocks a lot of the light from anything other that stood dead centre over the pedal. Having some light cast off to the sides would be a help.

As it is though, these diffuse the light really well, they also look good too.
I have them installed on a Vemuram Rage E and RockFabrik Mind Abuse. Both pedals have searing LEDs bit are nicely tamed by these dampers.
I do think in a lot of cases the plain white 'bubble' dampers would be just as good, if not better.
These just look a bit flashier, but do the same job and cost a bit more.