D
Not… what I expected
Ordered this as a replacement for my Strat but when I received I realized it’s not the shimmering 3D effect that’s normally on any Fender tortoise colored pickguards, but simply printed on. Not at all what I expected, hence I haven’t even bothered to check the fit.
0
0
Anmäl recension
A
Great value and quite nice looking
Good fit for my Crafted in Japan 2002 Stratocaster with 70s big headstock.
The tortoise print could have been a bit more elaborative but you get what you pay for and it is not at all bad really.
I was worried that it would be too thin, but the thickness is perfectly adequate and does not feel flimsy at all.
The screw holes did line up nicely, with one or two ofsetted with perhaps one mm, but not a problem when tightening lightly.
The tortoise print could have been a bit more elaborative but you get what you pay for and it is not at all bad really.
I was worried that it would be too thin, but the thickness is perfectly adequate and does not feel flimsy at all.
The screw holes did line up nicely, with one or two ofsetted with perhaps one mm, but not a problem when tightening lightly.
0
0
Anmäl recension
g
bättre än andra sett till priset
Jag kan inte se någon annan skillnad vare sig i hantverk eller utseende
Bara att passa in den,,, det är: att fila- slipa lite för perfekt passform och fixa nya hål i kroppen om hålen ej passar på en gång1? men det är bara skoj att pula lite med billiga strat kopior
KÖP KÖP KÖP!
Bara att passa in den,,, det är: att fila- slipa lite för perfekt passform och fixa nya hål i kroppen om hålen ej passar på en gång1? men det är bara skoj att pula lite med billiga strat kopior
KÖP KÖP KÖP!
0
0
Anmäl recension
A
Prisvärt
Countrypimpade en gammal hpd-strata med denna, passade nästan perfekt. Skruvhålen var inte riktigt där de skulle men gitarrkroppen är av okänt ursprung så det kan lika gärna vara där felet sitter. Mycket nöjd ändå, billigt billigt!
0
0
Anmäl recension
F
Bra kvalité, fin finish. Bortsett från att jag fick fila en halv millimeter vid stallet så passade den perfekt på squier strat.
0
0
Anmäl recension
M
Nice
Looks nice, perfect fit for MX strat. But has no sheilding.
0
0
Anmäl recension
A
No problem
Bought this one to pimp an old Squier Affinity with the dull white pickguard, Good fit and looks fine.
Otherwise IF you end up with slightly offset holes a tip is to put a piece of match stick or toothpick in the old hole.
Otherwise IF you end up with slightly offset holes a tip is to put a piece of match stick or toothpick in the old hole.
0
0
Anmäl recension
A
jå tak så miket
men det jåg inte gilar er faktisk at det knap-hål där upe er aldeles for hög upp so jåg slår i det när jag spela
0
0
Anmäl recension