Med våra cookies vill vi erbjuda dig den bästa möjliga shoppingupplevelsen med allt som hör till. Detta inkluderar till exempel lämpliga erbjudanden, personliga annonser och att komma ihåg preferenser. Om detta är okej för dig, godkänn helt enkelt användningen av cookies för preferenser, statistik och marknadsföring genom att klicka på "Okej!" (visa alla). Du kan när som helst återkalla ditt samtycke via cookieinställningarna (här).
Bought to connect an Arturia Keystep to a Volca Modular and it works well, as expected.
I could have saved a bit of money by buying a separate Y-splitter and a couple of cables instead, but this kit is really good quality and fits together very solidly - much better than the cheap cables that I would have otherwise bought. Very happy that I chose to go with this kit.
Yes, it just works. Cables quality is top notch and I believe this is the simplest and, overall, all in one solution for using with any sampler. You can't go wrong with this. This is very straightforward and handy cable combination.
Must have cables if you're using Elektron A4 with a Modular synth to send CV
AlexanderSKG 02.12.2024
Well build cables, you can feel the quality when you hold them. I can trigger my modular case with the CV out of Elektron A4 and use its sequencer since I don't have a module for that application.
Cons:
Way too bulky
Way too expensive
A stupid solution to a simple problem
Elektron created a problem by using TRS sockets for the CV outs on the A4 Mk1. The only thing Elektron needed to make was a cable with a 1/4" trs jack at one end and two 1/8" mono jacks at the other end (which is not a common cable).
Owners of the A4 Mk2 do not need to buy this product because the CV outs are on 1/4" mono jacks so they can connect to anything they want using common commercially available cables.